€15 shipping in the EU · €29 to the rest of Europe, DHL with tracking · Secure checkout
Teltonika RUTX09 router, front view
Product photo: Teltonika Networks
RUTX series · power guide

Teltonika RUTX09 power supply and cables

Three ways to power the Teltonika RUTX09, an industrial 4G router: a 230 V wall supply, a 12/24 V car cable and a screw terminal cable. All fit its 4-pin socket.

  • 4-pin socket
  • 9 to 50 V DC
  • Peak 6 W at 12 V
  • EOL announced

We sell the cable, not the router. This page is about powering the Teltonika RUTX09. We make the cables and the supply. The router itself comes from Teltonika and its resellers.

230 V power supply for Teltonika routers

230 V power supply

For a desk, a shop or any spot with a wall socket. Uses about 33% of the supply at peak.

€13.95 incl. VATBuy now
EOL announced

Teltonika has announced end of life for the Teltonika RUTX09. Orders are accepted until 3 February 2027, production runs until 3 August 2027 and support continues until 3 August 2032. Teltonika names the Teltonika RUTM09 as the replacement. According to Teltonika's wiki it has a 4-pin 9 to 50 V socket, so our cables fit it as well.

About the Teltonika RUTX09

The RUTX09 is a RUTX router with LTE-A Cat 6, dual SIM, GNSS and four Gigabit Ethernet ports, but no Wi-Fi. It is built for wired installations where Wi-Fi is not wanted or not allowed.

It is found in transport, telemetry and secure sites where only cables are permitted on the LAN side.

Teltonika RUTX09 at a glance

Mobile
4G LTE-A Cat 6
Ethernet
4 x Gigabit RJ45
Wi-Fi
None
SIM
2 x SIM
Extras
GNSS, USB
Power input
9 to 50 V DC, 4-pin socket
I/O on power socket
1 digital input, 1 digital output
Peak draw at 12 V
6 W (497 mA)
Size
115 x 44.2 x 95.1 mm
Status
End of life announced (support until 3 August 2032)

Power socket pinout

PinFunctionOur wire
1Power (+)Red
2Ground (-)Black
3Digital inputGreen
4Digital outputWhite

The car cable and the 230 V supply only use pins 1 and 2. The I/O wires are on the screw terminal cable.

How much power the RUTX09 draws

The draw is low: 1.4 W at idle and 6 W at full load, measured by Teltonika at 12 V. That peak works out at about 497 mA, or 33% of our supply's rating. At 24 V Teltonika lists a peak of 5.8 W.

Peak at 12 V: 6 W of the 18 W our 230 V supply delivers

Which cable should I pick?

  • Wall socket. For a desk, a shop or any spot with a wall socket. Uses about 33% of the supply at peak.
  • Vehicle. For 12 V cars and 24 V trucks. The RUTX09 accepts up to 50 V.
  • Cabinet, battery or solar. For DC rails, batteries and solar. Green and white bring out the I/O. Add a 2 A slow-blow fuse near the source.

Install tips

  • The RUTX09 accepts up to 50 V. That gives extra margin on 24 V vehicle systems, but a quality supply is still the safer bet.
  • The Teltonika RUTX09 is rated to 50 V, which gives good margin on 24 V vehicles. A clean supply is still the best protection against spikes.
  • Do not let the cable hang from the plug. A cable tie a few centimetres from the socket stops vibration from working it loose.

Teltonika RUTX09 power FAQ

?What voltage does the Teltonika RUTX09 need?

The Teltonika RUTX09 takes 9 to 50 V DC, so 12 V, 24 V and even 48 V systems are within range.

?Does the Teltonika RUTX09 come with a power supply?

Yes. Teltonika ships the RUTX09 with a 12 V, 1.5 A (18 W) wall adapter, the same 12 V and 18 W as our 230 V supply. A second cable makes sense for spares, a second site, or an install where a wall plug is not practical, such as a vehicle or a DIN rail cabinet.

?What will replace the Teltonika RUTX09, and will the cable fit?

Teltonika lists the RUTM09 as its replacement. According to Teltonika's wiki the RUTM09 uses a 4-pin socket with 9 to 50 V, so our cables fit both.

?Can I use the input and output on the Teltonika RUTX09 with your cable?

Yes. The screw terminal cable brings pin 3 (digital input) out on the green wire and pin 4 (digital output) on the white wire. Configure them in RutOS under Services, Input/Output.

?Is the 18 W supply strong enough for the Teltonika RUTX09?

Yes. The Teltonika RUTX09 peaks at 6 W on 12 V, about 33% of the supply's rating.

?Do you sell the Teltonika RUTX09 itself?

No. We only make the power cables and the supply. The Teltonika RUTX09 is sold by Teltonika's distributors.

Related Teltonika models